McNett ReviveX Spray-On

From jackets to backpacks, this stuff works pretty well. I don''t have any complaints because I knew what I was paying for when I got it. This is not meant to be a one-time, spray and forget product. Make sure you have washed the item you''re going to spray, or at least get it sopping wet, then spray liberally onto item, throw it in the dryer and let the heat do the rest. Let it sit a day or two if you can. In my experience, it seems to increase the effectiveness. No big deal if you can''t, certainly don''t have to. For $12, this''ll get you through one hard season. Very easy to apply. If you can curl your finger, you can use this stuff. Don''t be afraid to over-apply, there''s no such thing. Every time I''ve used it, I have not been disappointed. Haven''t got wet yet!

So this stuff does work and it makes your jacket look great. The fabric seems to laydown and form a nice even surface and looks like it would when it was "newer". I did notice after wearing it everyday for a couple of weeks, that it started to return to it''s "older" look where the surface was very soft and looking a bit worn. The "beading" properties were reduced even though it only rained a couple of times on the jacket (The North Face, Mountain Jacket), walking from my office to my car (about 150 yards). It didn''t take long for the water to soak through the outer layer, stopping at the gore tex lining, it began to feel clammy again. It already seems as if I need to retreat it. I''ll write back to update after the next down pour.

I would get it again though, as it does return it somewhat to it''s original water repellancy. This bottle, looks like it can do two jackets once.

Buy McNett ReviveX Spray-On Now

I got this to spruce up an old Gore-Tex jacket I have that is probably 20 years old. I had already washed and dried the jacket, so when I went to use the ReviveX, I had to get it wet again, so I ran it through the rinse cycle once more. Application was a little tedious, and I used my other hand to sort of wipe the stuff into the fabric better. Then, as weird as it felt, I followed the directions and tumbled the jacket in the dryer for 60 minutes. I didn''t put it on high, because my drier gets so hot it melts things. The low setting still gets very warm, and when I checked on the jacket, it was hot to the touch, so I think it was warm enough.

I haven''t tried it in a true downpour, but just wearing the jacket around town in the rain, the water beaded up very nicely. The color also actually looks more vibrant, too.

I think most of the Gore-Tex has worn off the inside of this jacket, so I don''t think it will do quite as well in an extended downpour. Plus, all the seam tape had come off and I didn''t want to pay lots of money to have it re-taped. So, I used some McNett Seam Sure on the inside of all the seams and let this thoroughly dry. I did this before I treated it with the ReviveX. (It looks a little ugly where the seam sealer leaked through the fabric on either side of the seams, so if you choose to do this, try and only paint where the original seam tape was.) But this jacket is just for doing yardwork in the rain, so it''s okay if it is a bit ghetto.

ReviveX costs a bit more than most silicone sprays, but is supposed to be the best thing to use on Gore-Tex because it won''t interfere with breathe-ability. If you''ve got a genuine Gore-Tex or similar article of whatever, pay a few extra dollars for the good quality waterproofing, like ReviveX. Don''t get the cheap silicone stuff which can clog the Gore-Tex. You''ll be glad you went the extra mile when your stuff is like new again.

Read Best Reviews of McNett ReviveX Spray-On Here

I applied this to my aging rain shell several weeks ago using the instructions on the bottle. After removing it from the dryer, I ran the faucet over the jacket for about 30 seconds and the water shed right off.

When I take it out in the rain, water beads up and sheds for the first few minutes but the jacket thereafter begins to soak. However, I suspect that this is due to fact that I used Woolite while washing the jacket as this happens every time I enter the rain after the jacket dries (i.e., it repels water at first and then absorbs). Just before I applied the ReviveX, water was no longer beading up so I think it is safe to assume that the jacket has retained whatever the ReviveX added despite being rubbed on the shoulders and neck by my backpack.

I intend to test this on another jacket that has been washed properly to see whether the spray or I am at fault for the jacket leaking.

Want McNett ReviveX Spray-On Discount?

I used this product to waterproof some old synthetic/gortex jackets that had lost their waterproof ability. It worked great and I recommend it.